The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 24, 2011, 01:25 PM   #1
ArizonaRick
Member
 
Join Date: November 1, 2006
Location: Southern Missouri - Ozarks
Posts: 89
S&W Mod 10-8 4" not indexing

I recently cleaned my S&W Mod 10-8 (4" hvy bbl) and I removed a lot of built up crud behind the hand - 10 years of weekly shooting. Now it appears as if the hand does not protrude forward enough to catch the ratchet face on the cylinder (extractor). Is there a simple solution to this problem. Does a new over sized hand need to be fitted? Any help would be appreciated. End shake has been corrected.
ArizonaRick is offline  
Old September 24, 2011, 02:13 PM   #2
Whirlwind06
Senior Member
 
Join Date: March 3, 2006
Location: NE Ohio
Posts: 727
Is it possible that you reassembled it incorrectly? I would be suprised that a good cleaning would make functioning pistol not work.
Whirlwind06 is offline  
Old September 24, 2011, 02:14 PM   #3
Don P
Senior Member
 
Join Date: December 17, 2005
Location: East Central Florida
Posts: 4,709
Maybe you put something together incorrectly. I doubt the smegma was making the gun function properly
__________________
NRA Life Member, NRA Range Safety Officer, IDPA Safety Officer
As you are, I once was, As I am, You will be.
Don P is offline  
Old September 24, 2011, 07:03 PM   #4
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,773
As above, you either failed to reassemble it properly, or some hard fouling displaced and fell into the action and is jamming it.

Most likely suspect if you disassembled it is that you failed to get the spring on the hand correctly located, or it slipped loose and you didn't notice.
Dfariswheel is offline  
Old September 24, 2011, 07:35 PM   #5
James K
Staff
 
Join Date: March 17, 1999
Posts: 18,647
If you removed the hand from the trigger, chances are that you disengaged the hand spring, which is inside the trigger and bears on the little forward pin in the hand. If that is the case, take the hand and trigger out again and use a small screwdriver to lift the spring so the hand can be put in right. Don't reassemble the gun until you are sure the hand has the proper tension.

Jim
__________________
Jim K
James K is offline  
Old September 29, 2011, 07:44 AM   #6
ArizonaRick
Member
 
Join Date: November 1, 2006
Location: Southern Missouri - Ozarks
Posts: 89
That was it!

Thank you Jim, that was exactly the right fix. I appreciate your response.
ArizonaRick is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07349 seconds with 9 queries