The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 8, 2011, 09:09 AM   #26
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 2,881
Quote:
I noticed that 1 out of 10 pieces of brass will not wind up with the shoulder bumped back as far as the others....
After several firings (in my own M1A), I see the same thing. Since I use a headspace gauge to do a quick look at cases after sizing, I'll occasionally see cases as much a 0.002" off what my target dimension is. Those I'll run back into the sizer and "bounce" against the top (case backed off a 1/4" and then bumped back fully up into the die) to fix.

I attribute this to different brass "spring" as the shoulder fire-hardens. Were I to be keeping these cases past the nominal 4-5 reloadings (for an M1A), I'd anneal and move on.
mehavey is offline  
Old April 8, 2011, 02:57 PM   #27
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 2,671
We can talk it to death, memory, recovery, spring back or 'jump back'? If the case is whipping the press and is 'tuffer' than the press someone should consider the case has resistance to being sized, could be acquired resistance to being sized, it could be caused by the vain reloader trying to get 50 firings out of a case? I do not know, It does not get better than using new cases, after that it is up-hill.



F. Guffey

Last edited by F. Guffey; April 8, 2011 at 03:26 PM.
F. Guffey is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07127 seconds with 9 queries