The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 10, 2011, 10:24 PM   #1
bravo124
Senior Member
 
Join Date: September 9, 2009
Posts: 120
Seating a Magazine Tube

Can someone explain how to properly seat a new magazine tube into the receiver of my Ithaca 37. I unscrewed the old one to have the receiver blued and bought a new one to install. Any help would be appreciated.
bravo124 is offline  
Old March 10, 2011, 10:39 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,343
Huh? Doesn't it screw in the same way the old one screwed out? You will need a strap wrench though, and be careful not to crush that tube as it is fairly thin.

Remember, you are not dealing with a barrel, so don't overtorque, just a good snug fit should be enough.

Jim
__________________
Jim K
James K is offline  
Old March 11, 2011, 11:56 AM   #3
oneoldsap
Senior Member
 
Join Date: September 16, 2009
Location: I live in the foot of the Green Mountains of Vermont
Posts: 1,585
You don't need a wrench of any kind . Just put a dab of Lok Tite 242 on the threads , hold receiver firmly and screw in with both hands till snug and you're good to go . Even a strap wrench will dent the tube !
oneoldsap is offline  
Old March 11, 2011, 03:46 PM   #4
bravo124
Senior Member
 
Join Date: September 9, 2009
Posts: 120
Thank you for the replies. I was told that the mag tube had to be "seated" in the receiver or the shells won't load properly. That's why I asked first.
bravo124 is offline  
Old March 20, 2011, 06:58 PM   #5
nogo
Senior Member
 
Join Date: September 7, 2009
Location: central texas
Posts: 211
Clean any bluing process residue from receiver screws. Very lightly oil to prevent rust and do same for new tube. Screw in hand tight. Screw on mag cap and then gently tap with wood handle or plastic tool handle. Hand tighten once more and repeat tapping. Avoid loc-tite until you verify that gun will feed ok.

Re-assemble. You may choose not to use the loc-tite.
nogo is offline  
Old March 21, 2011, 07:50 PM   #6
jrothWA
Senior Member
 
Join Date: November 11, 2006
Posts: 1,943
"Seated" means that there is NO...

gap between the tube and receiver, that can catch a rim.

That transition MUST be smooth, both ways, as you load the shell into the mag and the action receives as it cycles.
jrothWA is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:33 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07308 seconds with 9 queries