The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 3, 2011, 06:10 PM   #1
Stump1
Member
 
Join Date: March 20, 2006
Posts: 21
Pulled plated bullets

I recently loaded a batch of .45 plated HBRN a little light, so they didn't cycle the action in either of my pistols. I've started pulling them, and they are all in good condition, but you can see where the case had pressed on the bullet during final sizing. Is there any reason not to reuse these bullets? I couldn't take a picture good enough to see anything visible in the bullets.
Stump1 is offline  
Old March 3, 2011, 07:04 PM   #2
peter_s
Member
 
Join Date: January 25, 2011
Posts: 46
I've reused plated bullets that I've pulled. It seems the only marks tend to be from the crimp, but I'd just check the diameter where they were seated. I'm sure they would be fine to reuse.
peter_s is offline  
Old March 3, 2011, 10:45 PM   #3
billnourse
Senior Member
 
Join Date: September 16, 2010
Location: Bloomfield, NM
Posts: 366
No problem in using pulled plated bullets. The little grove from the crimp should be no issue.

Bill
__________________
Cooper 52 25/06, Cooper 52 30/06, Cooper 52 338/06Cooper 57 .17HMR, Remington VS .22/250 all left handed. Rock River Predator Persuit AR-15, 1952 Marlin 336 in 30/30. 2 Kimber 1911, Colt 1911, S&W .357 Mag, Kahr .40 and .380
billnourse is offline  
Old March 3, 2011, 10:50 PM   #4
Miata Mike
Senior Member
 
Join Date: May 22, 2010
Location: North East WI
Posts: 417
Tonight I was showing a buddy of mine how to load .40S&W loads, and I then switched to my .45acp turret to show how easy it was to change calibers. I loaded a pulled plated bullet and everything measured on the money.
Miata Mike is offline  
Old March 3, 2011, 11:24 PM   #5
dawico
Senior Member
 
Join Date: October 18, 2009
Location: Lampasas, TX
Posts: 326
Your rifling is going to do way more damage then your crimp ever could. Load them up.
dawico is offline  
Old March 4, 2011, 09:42 PM   #6
Stump1
Member
 
Join Date: March 20, 2006
Posts: 21
Thanks

I figured that it shouldn't be an issue, but I thought I'd ask. Thanks for the help.
Stump1 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:19 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06987 seconds with 9 queries