The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 6, 2000, 04:16 PM   #1
Roger C
Junior Member
 
Join Date: October 4, 2000
Posts: 13
Anybody out there using a Dillon Square Deal B to load .40 S&W for a Glock? I'm using one now for 9mm, and want to start loading .40 for a G35. Anybody out there already doing it? Do the proprietary Dillon dies size the brass down enough after being fired in a Glock chamber?
Thanks!
Roger C is offline  
Old December 6, 2000, 06:40 PM   #2
JHS
Senior Member
 
Join Date: November 30, 1998
Location: Goodwell,Ok.
Posts: 505
dies

I am using dillon dies for the .40. no trouble. I may get the lee factory crimp die for the last stage. Just haven't convenced myself that I need it yet.

JHS is offline  
Old December 8, 2000, 12:11 PM   #3
TaxPhd
Senior Member
 
Join Date: October 29, 1998
Location: Colorado
Posts: 534
JHS,

That won't work for Roger. The SDB uses a die set that is unique to that press, and they are different than the regular Dillon Dies (or any other die). The lee factory crimp die won't even go into the press.
__________________
TaxPhd

"Those who live by the sword are probably pretty f***ing good at it."

"Instructions for a successful gunfight: Front Sight, Press Trigger, repeat
as necessary." - B. Braxton
TaxPhd is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:51 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05779 seconds with 9 queries