The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old June 5, 2010, 10:20 PM   #1
trg42wraglefragle
Senior Member
 
Join Date: April 21, 2008
Location: new zealand
Posts: 838
aluminum bedding

Hi all.
I am thinking of making a new stock for my Tikka T3 in 223,
I am wanting to put aluminum bedding into the stock and would like to know if there are any websites that show you what it should look like or if anyone here has any pictures of what aluminum bedding looks like.
I've been trying to find some decent information and photos but aren't having any luck.

Would appreciate any help,
thanks
trg42wraglefragle is offline  
Old June 6, 2010, 12:54 AM   #2
DnPRK
Senior Member
 
Join Date: August 24, 2001
Location: LC, Ca
Posts: 1,778
An aluminum bedding block precisely matches the contour of the bottom of your receiver. The front of the aluminum bedding block is precisely machined to be square with the aft side of the recoil lug. The bedding block has holes for the action screws and a cutout for the magazine well and trigger. The bedding block is then permanently glued into the stock.

http://www.midwayusa.com/viewproduct...m_campaign=649
DnPRK is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05525 seconds with 9 queries