The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old May 30, 2010, 08:36 PM   #1
mike6975
Senior Member
 
Join Date: June 29, 2008
Posts: 104
DIY sbs

i have the form in hand(looking at it),now i want to make my own sbs,pump shotgun,a little longer than a serbu,but short enough that the magazine tube,and action bars need modification(have a shop full of tools also)could i get some insight or advice from anyone who's done there own mods such as this?.i appreciate any and all input you have for me.


Respectfully,


mike
mike6975 is offline  
Old June 2, 2010, 04:38 PM   #2
drail
Junior member
 
Join Date: February 2, 2008
Posts: 3,150
I don't think you are going to find the information you need on this particular forum. Good luck on your project though.
drail is offline  
Old June 2, 2010, 11:01 PM   #3
Joat
Senior Member
 
Join Date: March 31, 2008
Location: Dayton, TX
Posts: 383
Shortening the mag tube is easiest if you shorten it from the receiver end of the tube, unless you have a lathe and can re-thread the end. The magazine tube is soldered nto the receiver and will have to be removed and replaced with heat. Very carefully so as not to damage the receiver. Remember, the mag spring (and possibly the follower)will also have to be shortened.

The easiest way to modify the action bars is to take the material out of the middle of the bars and weld the ends back together, kind of like chopping the top on a car. After welding the bars they will have to be drawn and tempered to prevent cracking.

Unless you are moving the barrel ring back neither of these operations is necessary. If you are, the ring is brazed in place and must be properly orientated to, and spaced from the bottom, of the barrel when put back on. Once again tempering and drawing post welding will be required to maintain the needed strength. If you are not experienced with precision welding, seek competent help before putting fire to metal.

Good luck, build it as described ont the form 1, take a lot of pictures, and share your experience when you're done.

Joat
__________________
All things being equal, fat people use more soap. (I know I am one.) High speed, low drag does not even come close to describing ME.
Joat is offline  
Old June 3, 2010, 08:48 AM   #4
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
Go to the NFA section - you need the paperwork completed BEFORE you begin cutting
oneounceload is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:10 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06046 seconds with 9 queries