The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old May 22, 2010, 08:10 PM   #1
AR FUN
Member
 
Join Date: February 2, 2005
Location: SHEPHERDSVILLE KENTUCKY
Posts: 58
Remington 870 Forend Assembly Replacement

Have any of you guys replace the forend tube assembly on an 870 Wingmaster before? The serial number is a V Number V. The end of the tube has broken off in end of the action bars. Is this brazed in? How can a guy go about replacing and should this be left to a much more experienced smith. I have rebuilt actions and receivers before staking and replacing parts. This a gun with sentimental value and would like to repair myself if possible.

Thanks

Greg
AR FUN is offline  
Old May 23, 2010, 01:54 AM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,536
The forend tube is very easy to replace, and the parts are available from Numrich. Remove the barrel, remove the trigger group, remove the bolt carrier, slide the forend tube off the mag tube, remove the nut with a spanner, remove the forearm, then reassemble in reverse order. The forearm nut is staked, but just give it a twist and the staking is gone. Use LocTite when reassembling, it works better than staking.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Old May 23, 2010, 06:59 AM   #3
AR FUN
Member
 
Join Date: February 2, 2005
Location: SHEPHERDSVILLE KENTUCKY
Posts: 58
Thanks

I appreciate the information. I will give it a try.

Thanks Again

Greg
AR FUN is offline  
Old May 27, 2010, 10:41 PM   #4
dksac2
Member
 
Join Date: May 17, 2010
Posts: 62
A good tig welder or someone who is very good with a wire welder can re attach the action rods.
I've done more than a few with a wire welder.
Clean up any slag with a Dremel tool and use cold blue on it.
This way you keep your original parts.
Keep the weld small. You might still have to take a little wood out of the forend for a good fit.

Best Regards, John K

Last edited by dksac2; May 27, 2010 at 10:51 PM.
dksac2 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06477 seconds with 9 queries