![]() |
|
|||||||
| Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
|
Thread Tools |
|
|
#1 |
|
Senior Member
Join Date: February 16, 2009
Location: Colorado Springs CO/Columbus GA
Posts: 154
|
multigun/3 gun competition
just wondering what sights you use. i see most guys using a 1-4x but the ranges seem so short that a reflex would do fine.
__________________
True Grit |
|
|
|
|
#2 |
|
Senior Member
Join Date: November 22, 2006
Posts: 1,355
|
The 1-4X is slower up close but nice for longer shots. I like both.
|
|
|
|
|
#3 |
|
Senior Member
Join Date: March 1, 2000
Posts: 4,841
|
A dot is great, until you get to the 350yd stage. A lot of shooters like a 4MOA dot, and at 350 yards, that would completely subtend a 12" target. I use iron sights.
|
|
|
|
|
#4 |
|
Senior Member
Join Date: February 16, 2009
Location: Colorado Springs CO/Columbus GA
Posts: 154
|
yea i've seen that docter side mounted like that a couple times. not too bad if i say so myself. never done a 3 gun so i'm just not sure what the average dist for the rifle is. i'd assume anywhere from 10-350m?
__________________
True Grit |
|
|
|
|
#5 |
|
Senior Member
Join Date: April 23, 2007
Location: Red Rock. TX
Posts: 759
|
Many club matches are short range, basically pistol matches with a long gun. Those are ok with 1x. Stick with those, fine. However, I just shot the Larue match - out to 440 yds. Set the 1.1-4x to 4x for that one.
Just a note - Having a scope and a dot will put you in Open division. It is possible to add open sights on an angle mount, and stay in Tactical. Lee |
|
|
|
|
#6 |
|
Senior Member
Join Date: February 16, 2009
Location: Colorado Springs CO/Columbus GA
Posts: 154
|
hey jmorris, where did you get that mount?
__________________
True Grit |
|
|
|
|
#7 |
|
Senior Member
Join Date: November 22, 2006
Posts: 1,355
|
There is no mount it's just a cmore off one of my open pistols bolted directly to the FF tube.
I intended to put it on a rail but that would have put it too high. As it is you just rotate the rifle with the same cheek weld to go from one to the other. |
|
|
![]() |
| Thread Tools | |
|
|