The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 12, 2010, 01:43 PM   #1
shootsafe
Member
 
Join Date: March 2, 2008
Location: Lincoln, NE
Posts: 86
CZ 75 front dovetail

I will be replacing my stock CZ75BD front sight with a LPA TTF86CZ.

Quesition.

What is the proper punch size to remove the front pin?
What is the proper drill bit size to drill the hole in the new front sight?

Thanks,
Shootsafe
shootsafe is offline  
Old May 18, 2010, 09:57 PM   #2
Jay1958
Senior Member
 
Join Date: November 26, 2007
Location: North Carolina
Posts: 274
Guess you never got an answer to your inquiry?

Did you get the sights installed? I ask because I am thinking about purchasing these sights for my CZ75 BD.

Thanks in advance!

Jay
Jay1958 is offline  
Old May 18, 2010, 10:07 PM   #3
dsa1115
Senior Member
 
Join Date: March 10, 2010
Location: Illinois
Posts: 428
Use a 5/64th punch and drill bit on the CZ.
dsa1115 is offline  
Old May 18, 2010, 10:08 PM   #4
schmeky
Senior Member
 
Join Date: February 11, 2006
Posts: 800
Shootsafe,

If I remember correctly, a 1/16" punch, I've changed out probably 30 or more CZ front sights. You don't drill the new site base, you grind it. I use a dremel cut-off wheel, but you could use a triangular file.

Install the new uncut sight and use a 1/16" drill bit twisted by hand, or in a hand held drill bit holder to scribe where the new groove is to be cut; be sure and mark both sides. Or use the same punch used to remove the roll pin to mark or index where you need to grind the bottom groove on the new front sight.
schmeky is offline  
Old May 18, 2010, 10:44 PM   #5
tschmittel
Member
 
Join Date: July 19, 2007
Location: Chicago area
Posts: 81
I just put sights on mine and the roll pin is 2mm or 5/64.http://czcustom.com/cz-factory-sights.aspx
tschmittel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06475 seconds with 9 queries