The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old April 6, 2010, 07:21 PM   #1
Todd Porter
Member
 
Join Date: November 4, 2007
Posts: 33
Glenfield model 30

Hello to all,
I just put on layaway a used Glenfield model 30 in 30-30. It was very reasonably priced, hence the reason I bought it, and is in very good condition.I need to pick a few brains with a few questions:

I know this is a Marlin rifle, where can I get it age checked? I am assuming that ALL gun manufacturers started putting the "WARNING" thing on their gun barrels in 1973 or so. This gun does not have one so I'm guessing it's older than that.

The gun has a 20 inch barrel, very clean rifling but looks like a fairly fast twist. Anyone know what the twist would be?like one in 14 maybe?

What ammo might work best, given the barrel length and twist?I'd prefer to use lighter loads, I do intend to hunt deer with it but don't see a need for anything heavier than 150-160 grs.( most shots 100 yds. or under)I also don't want to blow good money on cheap ammo, and I may start reloading again so case quality would be an issue.

Finally, does anyone other than weaver make a base for this gun? Weaver's are ok, just don't like the aesthetics, or lack of. Prefer something "cleaner" looking. Fairly cheap.

All responses will be appreciated, thanks.
Todd Porter is offline  
Old April 8, 2010, 07:38 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,817
For a date made, you can try the data base here:

http://oldguns.net/sn_php/marlinlookup.php

I think you can also call Marlin.

To measure the rifling twist, just run a cleaning rod and patch into the bore and measure how many inches it takes to make one turn.

There's a fairly wide selection of ammo out there, but I don't see any need for bullets heavier then 150 grains for deer hunting.

There are several bases for the Marlin rifles. Brownell's carry most of them:

http://www.brownells.com/.aspx/sid=2...tern_Field_740

http://www.brownells.com/.aspx/sid=1...ield_Model_740

http://www.brownells.com/.aspx/sid=5..._Specs_Fits__4
Dfariswheel is offline  
Old April 13, 2010, 01:38 PM   #3
ForneyRider
Senior Member
 
Join Date: December 4, 2007
Location: Forney, TX
Posts: 725
We got 3 bullets to touch with handloads of IMR 4064 and the Hornady 160gr FTX at 100 yards. Biggest issue with the 336W was cheap rings it came with.
__________________
When all is said and done, there is a lot more said than done.
ForneyRider is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:03 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06204 seconds with 9 queries