The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old April 2, 2010, 02:10 PM   #1
49willys
Senior Member
 
Join Date: March 18, 2010
Posts: 131
Homemade Garand gas plug

I was thinking on how to make my own adjustable gas plug,cheap like I am,and came up with a pretty simple idea I thought I would run by.I didn't search very hard before I just started typing,so if it has been done here already,I apologize and request a link.I thought I could drill and tap a hole in the end of the plug and screw in small allen head screws with small holes drilled into them,several screws with different sized holes to customize the outlet pressure,what do think?would this even work?
49willys is offline  
Old April 2, 2010, 04:18 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,962
Why not use the tappet type gas plug, tap the hole for an allen screw, then use it to push the tappet open until the right amount of gas escape is achieved.

Jim
__________________
Jim K
James K is offline  
Old April 8, 2010, 05:41 PM   #3
Chris_B
Senior Member
 
Join Date: February 9, 2007
Posts: 2,841
Aside from the challenge of doing it, may I ask, "why bother to make your own"? Commercial ones are available and are inexpensive
Chris_B is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:30 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06280 seconds with 9 queries