The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 2, 2010, 12:12 PM   #1
riverwalker76
Senior Member
 
Join Date: February 13, 2010
Location: Kentucky
Posts: 993
Rifle Bedding Recoat Question.

The bedding job I did last week needs a skim coat in certain areas to smooth out, and fill in areas that I filed down to make the action sit right.

Do I need to go over the whole 'modeling clay' spiel again, or can I just tape off the areas on the stock that are going to have Devcon near them?

In other words ... I don't want to have to go through the whole process of putting modeling clay in my mag well, receiver, and stock voids if I can get away with it.

Should I be ok as long as I ensure that I have a thorough taping and release agent coverage?
riverwalker76 is offline  
Old March 2, 2010, 01:23 PM   #2
edward5759
Senior Member
 
Join Date: September 15, 2009
Location: Phoenix, AZ. 30 miles from water, two feet from Hell.
Posts: 354
I use an acid brush and paint the area

I use an acid brush and paint the area that needs filling in Remember your release compound.
A skim bed is where I need to remove 1/8 inch and re-bed. The skim bed is for glass jobs that are old.
I coat the metal and stock in the areas with vasoline.
Ed
edward5759 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:13 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06244 seconds with 9 queries