The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old February 23, 2010, 02:22 PM   #1
Zip7
Junior Member
 
Join Date: July 22, 2007
Posts: 4
J Stevens 94A single barrel question

How do you disassemble the gun? I removed the forearm (1 screw) but it's not obvious how to seperate the barrel from the stock. Both my doubles are very simple - just remove forearm + open action.

Anyone know how do do this?
Zip7 is offline  
Old February 23, 2010, 05:31 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
AFAIK, it has exactly the same action as my 219B rifle, but with an exposed hammer - and breaks down just as you mentioned a double SxS shotgun does.

After the forend's off, when you break the action open as if to load, unhook the barrel from the receiver by pushing it a little towards the rear as you pivot it up/out, and it should come right apart.

.
PetahW is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:23 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06174 seconds with 9 queries