The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old February 20, 2010, 07:27 PM   #1
mich100
Junior Member
 
Join Date: February 20, 2010
Location: SE Virginia
Posts: 1
Using Old Powder

Any thoughts on the use of unopened cans of Red Dot that were manufactured in 1965? This has been stored indoors and the cans look very good, but the temperature in the building is not controlled and summer temperatures inside probably get over 100 degrees F.
mich100 is offline  
Old February 20, 2010, 07:45 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,822
Life is too short and guns are too expensive to take a risk on some old powder that likely deteriorated from the heat.

Gun powder can last a very long time under proper storage conditions, but when its not, it can be dangerous.
Unfortunately, I don't know of any way to test it to determine if its bad or good.

Best option, get rid of it by taking it out somewhere safe, pouring it out on the ground in a long line, and igniting it so it will burn up safely.
Dfariswheel is offline  
Old February 21, 2010, 01:03 PM   #3
James R. Burke
Senior Member
 
Join Date: January 3, 2009
Location: U.P. of Mich/Quinnesec
Posts: 1,897
Welcome to the forum, I agree probably good but why take a chance. Makes good fetilizere from what I hear.
James R. Burke is offline  
Old February 21, 2010, 01:42 PM   #4
Slamfire
Senior Member
 
Join Date: May 27, 2007
Posts: 4,034
This is put out here for risk assessment. You really have to look at what you have and make your own decisions.

I have access to a gentleman who is an energetics expert. I asked him about smokeless powder lifetime. The whole topic is a subset of “Insensitive Munitions”. A term you can Google and find bits and pieces in the public domain.

Smokeless propellants are used in more applications that just cartridges. Rocket motors, explosive warheads, these all use smokeless propellants.

He told me that powder starts deteriorating the day it leaves the powder mill. The rate of deterioration of double based powders is governed by the Arrhenius equation. http://en.wikipedia.org/wiki/Arrhenius_equation. Single based powders apparently deteriorate in a linear fashion.

What the expert told me was that double base powders are made of nitroglycerine (NG) and nitrocellulose (NC). The NG wants to wick its way, through capillary action, into the NC. Forming a lower energy state compound. In the process of combination nitric acid gas is released. As nature wants to go to a lower energy state, this reaction is inevitable. There are stabilizers in the powder which eat up the nitric acid. The stabilizers get consumed over time.

Exposing powder to high temperatures for extended periods of time is bad. Heat accelerates the reduction-oxidation process.

Cool dry storage conditions, he actually said “artic”, are about the best for long term storage of powder.

The expert said that Navy powders are initially tested at 10 years. They put a litmus paper in contact with the powder. If the paper changes color, nitric gas is present.

If the paper shows a problem, they then chemically test the powder for the amount of stabilizer in the powder. If that drops below 20% original, than the powder is scrapped. You have to have the original powder records to know how much stabilizer was in the powder when it was made.

The Army scraps by clock time. Double based powders are scrapped at 20 years, single based 45 years.

A few years ago TALON released tons of demilled military powders. That stuff was at the end of its service life. Half of my surplus 4895 powders went bad. One keg turned red and was outgassing and it was poured out on the lawn. About 8 pounds did not turn red, but went bad in the case. First indications that I had a problem were that loaded cartridges started having a lot of split case necks on firing. Then case necks started to crack on the loaded ammunition. When I pulled bullets, I smelt nothing, in the case or in the bottle, but I found green corrosion on the bottom of bullets. I believe that nitric acid was weakening the work hardened areas of the case, and causing corrosion on the bottom of the bullets.

Before pouring it out, I shot the stuff in Highpower matches. It actually shot very well but I had unusual retorts. Some load, some not so loud. The expert told me that pouring it out was the right thing because the retorts were indications that the powder was not burning consistently. Could have had a pressure spike.

If the powder changes color, it is bad. It is grossly bad. It was bad a long time before the color changed. And it is time to pour it out. That is when you typically see red rust in a metal powder can (acid gas eating the can up) and red powder.

Older powder, such as yours, has got to be at the end of its shelf life. I shot up cans of old Red Dot and Bullseye and did not have a problem. Does not mean you won't have a problem.

I was told that when enough nitric acid is released, the powder will spontaneously combust. The chemical reaction produces heat. He diagramed the chemical reaction and hot spots can develop as energy is released. As the Military is extremely scandal sensitive, they won’t tell anyone that big bunkers have blown up, but they have. Ammunition depots go Kaboom all the time due to old ammunition spontaneously combusting. You can Google this and find incident reports in the literature. But you won’t find mention of some of the American ammunition incidents that this guy investigated and wrote reports about. We Googled one and found nothing in the public domain.

Water is bad for smokeless gun powders as it damages the powder surface and wicks NG to the surface. Even though the reduction-oxidation reaction is reducing the total energy content of the powder , wicking NG to the surface will increase initial burn rate of the propellant, which has lead to pressure spikes.

Contact with rust is bad for powders. As I understand it contact with iron oxide increased the rate of the reduction-oxidation reaction. If you have dusty red rust in your can, dump the powder. Period.

The Navy used to store cannon powder in pools but the powder was to be recycled. I guess the water absorbed the nitric acid and kept everything cool, preventing heat build up. But the expert told me that the dry lifetime of powder is rapidly reduced after exposure to water.

Attached is chronograph data with Bullseye of different ages. Based on containers, I guessed that one can was made in the 80's, the metal can was probably 60's/70's.

I have totally loaded up the older powders and shooting them as quickly as possible.

Code:
Kimber Custom Classic 

230 gr LRN Valiant 4.5 grs Bullseye lot BE532 (80's mfgr)  Mixed Brass WLP (brass)
16-May-09	 high 83  °F		OAL 1.250"	taper crimp .469"
					
Ave Vel =	782.7				
Std Dev =	13.41				
ES =	52.05				
High = 	815.5				
Low =	763.4				
N =	28				
					
					
230 gr LRN Valiant 4.5 grs Bullseye 99' & 2005 mixed lot Mixed Brass WLP (brass)
16-May-09	 high 83  °F		OAL 1.250"	taper crimp .469"
					
Ave Vel =	805.2				
Std Dev =	38.07				
ES =	136.9				
High = 	912.4				
Low =	775.5				
N =	24				
					
					
230 gr LRN Valiant 4.5 grs Bullseye lot 827 (60's/70's powder) Mixed Brass WLP (brass)
16-May-09	 high 83  °F		OAL 1.250"	taper crimp .469"
					
Ave Vel =	822.9				
Std Dev =	14.14				
ES =	55.24				
High = 	853.7				
Low =	798.4				
N =	26
Slamfire is offline  
Old February 21, 2010, 01:55 PM   #5
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,400
Greetings mich100, and welcome aboard.

You might contact Alliant Powder to get their official slant. To dispose of unwanted powder, I found pouring it down an ant hill and sparking it off quite satisfying.
zippy13 is offline  
Old February 21, 2010, 02:38 PM   #6
mete
Senior Member
 
Join Date: June 14, 2004
Location: NY State
Posts: 5,326
Good powder has the smell of solvents. Bad powder has an acrid smell and a reddish or orange color.
mete is offline  
Old February 21, 2010, 07:26 PM   #7
44 AMP
Staff
 
Join Date: March 11, 2006
Location: Upper US
Posts: 11,214
Contacting the maker will do no good...

Because the answer will always be get rid of it (in a legally approved manner), and get new powder. They won't tell you anything else, due to possible liabilty issues.

While it is true that powder does deteriorate over time, and storage conditions have a lot to do with how much, and how fast, many times powders last a lot longer than we think they could. Some powders are much better at lasting than others. Some lots of a particular powder will last better than others, or worse. No way to know, really.

Basic test is smell, and appearence. If it look and smells like new powder, its probably ok. IF it doesn't then it might be ok, or it might not. If there is any doubt in your mind, its better to get rid of it.

I had about a third of a keg of Red Dot left, from when I bought it back in the mid 1980s. Its still fine. But it has been inside my house, and my A/C sucks. Inside temps in the 90s or slightly higher in the summer, some days. A little cooler where the powder is stored, .

Temps really start changing the powder when you get up close to 140, which is another reason being in the sunshine is a bad, bad idea.

I would take a sample of the powder, and load it cautiously (light load) and fire it in something strong (or expendable), and do it remotely, for a few rounds. Then if things look ok, you can start to carefully work your way back up to a standard load. If the cans are in good shape no bulging, rust, corrosion, or any other signs of a problem, odds are the powder has not reached a dangerous stage of its life. BUT, don't bet your life or safety on the odds. Test, carefully, or replace it.

Back in the 1970s, I remember reading an article about some IMR 4895 powder that was over 25 years old. The author had bought 100lbs shortly after WWII, and had left one keg in his mother's barn over the years, before finding it again, and testing it. It was fine, but delivered velocities about 100fps less than current production powder.
__________________
All else being equal (and it almost never is) bigger bullets tend to work better.
44 AMP is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07949 seconds with 9 queries