The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old December 27, 2009, 06:05 PM   #1
gus3836
Member
 
Join Date: November 13, 2007
Posts: 69
Torque wrench tester

Does anyone know to make something to test the torque settings of a wrench. I would think that if I have a known weight some how I should be able to test a wrench. Thanks Gus
gus3836 is offline  
Old December 27, 2009, 06:34 PM   #2
jeepershooter
Junior Member
 
Join Date: December 24, 2009
Location: Hawaii
Posts: 5
Your best bet would be to take your torque wrench(es) to a calibration lab. They have the proper torque standards to properly calibrate torque wrenches.
jeepershooter is offline  
Old December 27, 2009, 06:45 PM   #3
sholling
Senior Member
 
Join Date: May 18, 1999
Location: Hemet (middle of nowhere) California
Posts: 4,260
That's about all you can do.
__________________
Proud Life Member: National Rifle Association, California Rifle & Pistol Association, and the Second Amendment Foundation.
Annual Member: Revolutionary War Veterans Association (Project Appleseed) and the Madison Society.
sholling is offline  
Old December 27, 2009, 07:45 PM   #4
wogpotter
Senior Member
 
Join Date: September 27, 2004
Posts: 3,165
You'll need a couple of things.
Weights: These should be a set of 3 a LOW, a MEDIUM & a HIGH.

What's low medium & high? it depends on the wrench's range, but should be one almost at the bottom, one as close as possible to the middle & one high enough to be a similar amount away from MIDDLE as LOW is, but in the opposite direction.

Now you need a suitable way of hanging them, wire is pretty good because it's both flexible & strong & can be made into loops easily.

Next you need a strong bar over 1 Ft long, it needs to be strong enough to hold whatever you chose as HIGH horizontally with safety.

What you do is weld a socket to the bar, measure exactly one foot, & make a detent. Now you set the wrench, clamp it (or hold it depending on the weights) attach the 1 foot bar HORIOZONTALLY (this is important) & carefully hook on the weight using the cable or whatever as an attachment method. Each of the weights should be done 3 times. 1 is set slightly HIGHER on the wrench, it should indicate so however it indicates. then set dead right & finally set slightly high.

Repeat for the other 2 weights.

This should indicate both the LOW MIDDLE & HIGH offsets, if any, & allow you to graph a slope to show any corrections across the whole range.

The wrench is now set up for Lbs weight at Ft distance ie foot/pounds. You can use any converter to translate to newtons or whatever you need.
wogpotter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:47 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06346 seconds with 9 queries