![]() |
|
|
#1 |
|
Junior Member
Join Date: September 25, 2009
Posts: 10
|
slug in a mossberg 590
Can I shoot a winchester rifled slogs hollow point 12ga 2 3/4 " 1 oz in my mossberg 590 ?
|
|
|
|
|
#2 |
|
Senior Member
Join Date: September 8, 2004
Location: California
Posts: 148
|
Yes.
|
|
|
|
|
#3 |
|
Junior Member
Join Date: September 25, 2009
Posts: 10
|
I don't have a rifled barrel can i still shot a rifled slug threw it ? I am new to the slug world sorry for the dumb question .
|
|
|
|
|
#4 |
|
Senior Member
Join Date: April 14, 2008
Location: Texas Hill Country ranch
Posts: 433
|
General rule:
Rifled (Foster) slugs in smoothbore barrels; sabot slugs in rifled barrels. |
|
|
|
|
#5 |
|
Junior Member
Join Date: September 25, 2009
Posts: 10
|
Thanks
|
|
|
|
|
#6 | |
|
Senior Member
Join Date: February 15, 2009
Posts: 668
|
Quote:
Can you shoot? Yes. Should you? Probably not. Your barrel has rifling and shooting a standard lead slug through it will probably fill the rifling with that soft lead. Even a copper slug would leave behind much in the rifling. There's much debate as to whether or not "rifled" slugs actually spin out of a shotgun. (Maybe it's not so much debate, given modern high speed cameras and such, but perhaps I should say I'm ignorant of who won the debate that used to go on.) A rifled shotgun barrel can be really accurate but you must use the expensive sabot slugs to achieve that. So just what the other guy said: Old school rifled slugs for old school smooth barrels New school sabot slugs for new school rifled barrels |
|
|
|
|
|
#7 | |
|
Staff
Join Date: October 31, 2007
Location: Western Florida panhandle
Posts: 10,686
|
Barring further input from the OP...
Quote:
Brent
__________________
Finally have designs going up in the Hogdogs Outdoor Apparel online store. http://www.cafepress.com/hogdogsoutdoorapparel Thanks for lookin'... |
|
|
|
|
|
#8 |
|
Member
Join Date: September 4, 2009
Posts: 21
|
here is an excellent read to answer your question. i recently was asking the same question until i read this thread:
http://www.theboxotruth.com/docs/bot46.htm in short you can shoot both sabot and rifled slugs in a smoothbore, however you will not gain any discernable advantage with the sabots over the rifled and they are more expensive anyway.
__________________
Chuck Norris sleeps with a pillow under his gun. |
|
|
|
|
#9 |
|
Junior Member
Join Date: September 25, 2009
Posts: 10
|
So let me see if I got this right a sabot shell is one with the plastic thing on the inside of the shell that dose not let the slug touch the barrel .
|
|
|
|
|
#10 |
|
Senior Member
Join Date: March 5, 2009
Location: Uh-Hi-O
Posts: 1,932
|
That's right J-Dog. The purpose of a sabot is to allow a smaller caliber bullet to be fired from a larger bore. This allows for a higher velocity and flatter trajectory. Good if you are trying to make long range slug gun shots. I have seen an Ithaca Deer Slayer give 4 to 5 inch groups at 200 yards with those high dollar slugs. Mind you, this shooting was the result of lots of ammo testing and scope adjustment on sand bags. (A waste of money and time IMHO but it was my Uncle's money and gun so...)
You can tell them apart in the store by the word "Sabot" being on the boxes of deer slugs that cost an arm and a leg. (A $2.25 slug!? Not in this guy's gun) If you don't have a rifled barrel, don't waste your time/money on sabot slugs. Last edited by Willie Lowman; September 27, 2009 at 12:35 PM. |
|
|
|
|
#11 |
|
Senior Member
Join Date: November 7, 2008
Posts: 608
|
You might also consider Brenneke slugs (rifled) as they seem to be quite accurate when fired out of a smoothbore. But, this particular round can be expensive.
While I have certainly experienced decent groups (at around 60-75 yards or so) with various slugs out of my 590 (Brenneke and Federal LE Tactical), I generally reserve my shotguns (all smoothbores) for buckshot use.
__________________
Guns are similar, for instance, to automobiles; in the hands of the sane and responsible, they are generally harmless. In the hands of the insane, careless or malicious, they both become deadly. Blame the person, not the means....mechanical/inanimate objects have no mind of their own. Last edited by inSight-NEO; September 27, 2009 at 05:38 PM. |
|
|
|
|
#12 |
|
Member
Join Date: March 29, 2009
Posts: 30
|
I am a big fan of the Lightfields myself.
|
|
|
|
|
#13 |
|
Senior Member
Join Date: September 30, 2009
Location: Eastcoast
Posts: 140
|
Can you shoot buckshot thru a deer slug rifled barrel or will that also ruin the barrel ?
|
|
|
|
|
#14 |
|
Senior Member
Join Date: September 7, 2004
Location: SE NC
Posts: 1,223
|
It will likely leave you with a large load of lead to clean out of the barrel, but the only thing it will ruin is the pattern. Rifled barrels almost always open shot patterns up really fast, and usually leave a hole in the center to boot.
Stick with a smoothbore barrel, and shoot buckshot or rifled slugs. For rifled barrels, sabot slugs are best. lpl
__________________
Mindset - Skillset - Toolset. In that order! Attitude and skill will get you through times of no gear, better than gear will get you through times of no attitude and no skill. |
|
|
![]() |
| Thread Tools | |
|
|