The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting > Bullet Casting

Reply
 
Thread Tools
Old September 24, 2009, 02:06 PM   #1
awaveritt
Senior Member
 
Join Date: December 30, 2008
Location: Central Texas
Posts: 258
38/9mm bullet designs that are good in both.

What would be good compromises for bullet designs that would work in both a 38 revolver and 9mm pistol? If the barrels slugged close, I might could even size 'em the same. Anyone else done this?
awaveritt is offline  
Old September 24, 2009, 02:28 PM   #2
Russ5924
Senior Member
 
Join Date: February 18, 2005
Posts: 1,874
I would say a .356 in 9mm may work in both if the .38 is tight
__________________
Russ5924
Russ5924 is offline  
Old September 24, 2009, 07:24 PM   #3
IllinoisCoyoteHunter
Senior Member
 
Join Date: December 23, 2008
Location: Southern Illinois
Posts: 1,505
You could get a .358 mold and size it down to .355 or .356 for 9mm. Undersized lead bullets generally yield poor results. A round nose design would probably be the best as far as functioning in both (especially the 9mm).
__________________
~~IllinoisCoyoteHunter~~

~NRA LIFE MEMBER~
~NRA CERTIFIED INSTRUCTOR~
IllinoisCoyoteHunter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:01 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06202 seconds with 9 queries