The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old September 18, 2009, 04:16 PM   #1
Rocky72
Member
 
Join Date: June 22, 2009
Location: Tyler, Texas
Posts: 22
Stevens Model 940e Stock question

I am working on a Stevens Model 940e 20ga. I need a stock for it I don’t have one for it at all. This shotgun was found at the bottom of a cabinet and it had a bent barrel. I was able to cut the barrel down to 19" and was going to cut down a stock to make sure that it is inside the overall length of 26" to be legal this gun will be used as a snake gun that stays in the barn so looks don’t really matter. But a replacement stock for it is around $50 and don’t really want to spend that to just cut it up for this project. Now finally to the question, I was wondering if a Winchester stock would fit it or if there was an adapter that could be used. My problem is that like the Winchester the back of the receiver is V shaped making it hard to just fit a stock on it and with it being a single shot I can’t just put a pistol grip on it.

Thank you for your help
Justin
Rocky72 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05036 seconds with 9 queries