The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old May 23, 2009, 01:31 PM   #1
captkilowatt
Junior Member
 
Join Date: January 20, 2008
Location: Texas
Posts: 8
Beretta 92FS Lock Block Breakage

The first question I would like to ask is what if anything ,other than just wear, would cause a 92FS to fracture its lock block at one lug? This pistol was bought new from a large sporting goods store about 2 years ago for use in weekly IDPA matches and has maybe been fired 10,000 times with mostly factory standard pressure rounds.
The second question I would like to ask is what type of fitting might be required in the replacement of the broken lock block. I have changed barrels befor on 92FSs' and used the original lock block that was on the old barrel with the new barrel so as to have the lock block match the slide, but in this case the new lock block will not be mated to the slide of the repaired pistol.
Thanks
captkilowatt is offline  
Old May 24, 2009, 07:57 PM   #2
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,515
The cause was a defect in the heat treatment and breakage was pretty common with the US made guns; AFAIK, the Italian guns did not have the problem. I had not heard of any breakages recently and assumed the trouble was corrected.

You should be able to just install a new one, but they are in the $40 range so you might call Beretta and maybe they will agree to fix the gun for free.

Jim
__________________
Jim K
James K is offline  
Old May 26, 2009, 04:33 AM   #3
Hommbs
Senior Member
 
Join Date: June 1, 2005
Location: La Puente, California
Posts: 102
From what I understand the barrel torques when fired causing the block's left side to slam the frame. It may eventually fracture and break. The early blocks were machined with relatively sharp corners and stress cracked easier than the newer generation blocks which are machined with rounded corners. I had an early Italian first generation locking block break after many rounds fired too. I just swapped it out for another one and have been chugging along ever since. The maybe some compatibility issue beteen the generation of locking blocks and the pin that goes in them.
Hommbs is offline  
Old May 26, 2009, 05:04 AM   #4
JohnKSa
Staff
 
Join Date: February 12, 2001
Location: DFW Area
Posts: 18,346
The blocks eventually break. Some have been known to last 100K rounds or longer, but I believe that somewhere around 20K is probably more common. 10K rounds might be a little on the early side but I wouldn't immediately assume that it was any indication of a problem.

When you order the part it should come as a set with a plunger pin to fit it. If you order from Beretta that will happen automatically, otherwise you may need to specifiy. There should be no fitting required.
__________________
Did you know that there is a TEXAS State Rifle Association?
JohnKSa is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06274 seconds with 9 queries