yet another question about my jp sauer & son western marshal 357 magnum s/a revolver

Hellbilly5000 · April 19, 2009, 09:07 PM

I have found all but one part. I need a base pin for it and I was wondering if that base pin is the same size as another brand ( i.e. ruger ect.) and if they are interchangeable.

PetahW · April 20, 2009, 09:12 AM

If you have no other cylinder pin for a trial fit, have you measured the hole diameter & depth ?

A drill bit shank might get you close enough - or carry the cylinder to gunshows and ask the parts guys for a match.

**James K** · April 20, 2009, 03:27 PM

A base pin is usually an easy part to make if you can't find one.

Jim

April 19, 2009, 09:07 PM	#1
Hellbilly5000 Senior Member Join Date: March 24, 2009 Location: RGV, Tx Posts: 787	yet another question about my jp sauer & son western marshal 357 magnum s/a revolver I have found all but one part. I need a base pin for it and I was wondering if that base pin is the same size as another brand ( i.e. ruger ect.) and if they are interchangeable. __________________ And death climbs the steps one by one, To give you the rose that's been burnt by her son, Point me to the sky above I can't get there on my own, Walk me through the graveyard Dig up her bones

April 20, 2009, 03:27 PM	#3
James K Staff Join Date: March 17, 1999 Posts: 16,398	A base pin is usually an easy part to make if you can't find one. Jim __________________ Jim K

April 20, 2009, 09:12 AM	#2
PetahW Senior Member Join Date: September 19, 2008 Posts: 3,268	If you have no other cylinder pin for a trial fit, have you measured the hole diameter & depth ? A drill bit shank might get you close enough - or carry the cylinder to gunshows and ask the parts guys for a match.