The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Black Powder and Cowboy Action Shooting

Reply
 
Thread Tools
Old March 9, 2009, 08:03 PM   #1
j-bird
Member
 
Join Date: June 4, 2007
Posts: 24
Can a SAA clone be damaged from spinning?

...aside from dropping it on the floor. I recently purchased a Beretta Stampede (4-3/4") and am practicing my gun spinning technique. I've become pretty good at it. I know enough not to fan it. But it occurred to me that the trigger mechanism obviously takes some torque during spinning. Am I screwing up my gun?
j-bird is offline  
Old March 9, 2009, 09:15 PM   #2
CraigC
Junior member
 
Join Date: November 28, 2001
Location: West Tennessee
Posts: 4,300
No but I would make sure the hammer was all the way down and not in the safety notch. That would put a lot of unnecessary strain on the trigger nose (sear engagement).
CraigC is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:55 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05143 seconds with 9 queries