The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 31, 2009, 04:49 AM   #1
Derekadavis
Senior Member
 
Join Date: December 27, 2008
Location: Dallas,Tx
Posts: 102
P22 firing pin sticking

I know its a pos. First gun (young and dumb) cant sell. but aside from that, I went to the range and shot around 200-300 rounds though it about 2 weeks ago. no problems. yesterday took it to the range, got set up loaded a mag, chambered a round, took off the safety, aimed, pulled the trigger, and click!!. thought maybe a bad primer recocked pulled trigger and click. cycled the slide got a new round in there and click click click BANG!!! it finally fired. i tryed again and click, click, BANG! I put it up for the day. got it home got to looking at it. the firing pin is loose in the breech block. it moves freely forward and backward. no spring feel to it. when the slide slams forward when i release it the firing pin is pushed it where the hammer cant strike it. I dont know too much about the inner workings of a simi. Thanks in advance...
__________________
USCCA & NRA Member
Derekadavis is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05985 seconds with 9 queries