The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 1, 2009, 02:18 PM   #1
T.A.Sharps
Senior Member
 
Join Date: December 28, 2007
Posts: 675
AR Lower Q

I bought an AR-15 RRA lower and I am holding on to it until I get an upper.

I was letting my cousin check it out when I had to get something, then I remembered I didn't tell him not to pull the trigger because I heard it was bad if the upper is not on it. When I got back I told him, but then I looked and the hammer didn't look like it was in the same position. Like he might of pulled the trigger, he didn't say.

So in what way is this bad, and what do I need to do to correct it?

Thanks
__________________
" ...Said I never had much use for one. Never said I didn't know how to use it..."
"Your reality, sir, is lies and bladerdash, and I am delighted to say I have no grasp of it whatsoever!"
T.A.Sharps is offline  
Old January 1, 2009, 06:30 PM   #2
CowTowner
Senior Member
 
Join Date: October 17, 2007
Location: Cowtown of course!
Posts: 1,195
It can be bad because the forged alloy in front of the hammer was not designed to take the force of a hammer hit. It is very possible to break the lower receiver buy pulling the trigger without a stop block in place or the assembled upper installed. Check the area in front of the hammer for damage.
__________________
NRA Chief Range Safety Officer, Home Firearm Safety and Pistol Instructor
"There are three classes of people: those who see, those who see when they are shown, those who do not see."
Leonardo da Vinci
CowTowner is online now  
Old January 1, 2009, 07:12 PM   #3
dieselone
Member
 
Join Date: November 15, 2008
Posts: 40
The hammer will strike the rear wall of the mag well. Not the worst and it would probably take many repeat hits to cause damage but should still be avoided just as good practice. I alway hold the hammer if I am checking trigger/hammer function with the upper off.
dieselone is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05639 seconds with 9 queries