The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 24, 2008, 09:32 PM   #1
Rmart30
Senior Member
 
Join Date: June 20, 2008
Posts: 434
Removing rifle sights

ive got a winchester 1300 with rifle sights. Ive installed a scope on it and would like to remove the sights and bases from the barrel. How are the bases attached to the barrel?
__________________
Jetguns.com When you want better service from a online gun seller and someplace that actually will talk to you on the phone unlike "Duds" gun shop, try them.

http://www.gunbanobama.com <---MUST READ
Rmart30 is offline  
Old November 25, 2008, 12:06 AM   #2
ogree
Senior Member
 
Join Date: January 18, 2005
Location: Idaho
Posts: 146
I'm not a 100 percent sure on this but I believe they are silver soldered on.
You would have to heat them up with a torch to break the solder loose then clean up the residual solder from the barrel all of which will require refinishing the barrel.
The heat will discolor the blueing and there will not be any blueing under the sights themselves.
ogree is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:21 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.04803 seconds with 9 queries