The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 12, 2008, 06:43 PM   #1
Leedavisone
Member
 
Join Date: September 11, 2008
Posts: 33
Removing Screws From A Stock

I am going to carve a new stock for a Winchester 94 (1949), and I have the grip removed, but I'm having problems with the butt stock. There are two screws that go through the tang just back of the trigger, and they are frozen. I can probably get them out, but will bugger up the heads most likely. Is there a way to make it easier to remove them? Also, if I mess them up, is it possible to get replacement screws somewhere? I'd appreciate some advice on this one...
Leedavisone is offline  
Old November 12, 2008, 07:27 PM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
The only screw, requiring removal to allow the buttstock to be pulled off towards the rear, is the tang screw.

The tang screw is the last screw, towards the rear, on the top rear tang.

If it's difficult to remove or frozen, it's lower/threaded end is the last/rearmost filled hole in the lower rear tang - which can be treated with a good penetrating oil for several hours before attempting removal.
Sometimes it's head gets a little rusty, where it can't be seen until removal - so you can treat it also.

If you feel a need to later remove the other screws, they can be treated likewise from inside the action, after the buttstock is removed.

.
PetahW is offline  
Old November 13, 2008, 12:26 AM   #3
gunn308
Member
 
Join Date: October 4, 2006
Location: Maine
Posts: 73
Put your rifle in a padded jaw vise and with a proper fitting screwdriver torque with one hand and tunk the head of the screwdriver with a hammer in the other if loosening doesn't work try tightening and tunking but the key is a proper fitting screwdriver this means absolutely no slop. If you do screw up the head Brownells or Numrich has replacements.
__________________
Oats that have already gone through the horse are always cheaper than oats that haven't !
gunn308 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:30 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07803 seconds with 9 queries