S&W Revolver Smith Recommendation

Gecko10 · September 22, 2008, 06:34 PM

I need to get some rear sight work done on a new to me S&W Mdl 66-2. There is no elevation adjustment so the spring clip, part#41 is more than likely shot, probably from over tightening by the original owner. These are very small parts and I do not have the proper tools or eyesight to replace these parts.

Any recommendations on a smith to do this would be greatly appreciated. I would prefer someone in the SW, but that's not 100% necessary and I prefer not to send the whole gun, just the rears which are easily removable.

Details of problem are here:

http://www.thefiringline.com/forums/...d.php?t=311829

WESHOOT2 · September 23, 2008, 12:23 PM

Can check here: www.americanpistol.com

and (even) here: www.gunsmithlocator.com

September 22, 2008, 06:34 PM	#1
Gecko10 Member Join Date: July 18, 2008 Location: New Mexico Posts: 46	S&W Revolver Smith Recommendation I need to get some rear sight work done on a new to me S&W Mdl 66-2. There is no elevation adjustment so the spring clip, part#41 is more than likely shot, probably from over tightening by the original owner. These are very small parts and I do not have the proper tools or eyesight to replace these parts. Any recommendations on a smith to do this would be greatly appreciated. I would prefer someone in the SW, but that's not 100% necessary and I prefer not to send the whole gun, just the rears which are easily removable. Details of problem are here: http://www.thefiringline.com/forums/...d.php?t=311829

September 23, 2008, 12:23 PM	#2
WESHOOT2 Senior Member Join Date: February 20, 1999 Location: home on the range; Vermont (Caspian country) Posts: 12,927	Guild Can check here: www.americanpistol.com and (even) here: www.gunsmithlocator.com __________________ . "all my ammo is mostly retired factory ammo"