The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 27, 2008, 10:35 AM   #1
SEG
Junior Member
 
Join Date: July 6, 2008
Posts: 3
Charter Arms 357 trigger pull

I have a New C/A 357 stubby with a hellish trigger pull. Is there any hope for freeing it up?
Ahy suggestion for replacement springs and weights?
Any issues YOU have had with replaceing springs?

Thnaks
Steve
SEG is offline  
Old July 27, 2008, 10:49 AM   #2
norsecat
Junior Member
 
Join Date: March 4, 2008
Posts: 12
Charter Arms 357 trigger pull

Contact Charter Arms about the trigger pull.
The support my fix it for you see there web sight and call them
Thy were very responsive to me when I cal them for Field King parts.
norsecat is offline  
Old July 27, 2008, 10:49 AM   #3
Slopemeno
Senior Member
 
Join Date: January 19, 2007
Posts: 2,347
Getting the trigger back in with its return spring was a treat...A loop of heavy monofilament hooked over the tip of the spring that points up and a slave pin through the trigger pivot worked for me, but I don't think I'd go there again. In the case of my Undercover, I've never seen so many razor sharp corners...

I used a Trapper spring kit on my Undercover, though I don't know if they're still in business. Wolf springs may carry some lighter return springs. I wouldn't go much lighter on the hammer spring.
Slopemeno is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:52 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06102 seconds with 9 queries