The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 29, 2007, 05:48 AM   #1
Stargazer
Senior Member
 
Join Date: August 6, 2006
Location: Republic of Texas
Posts: 506
Magtech primers, ever try any...?

I had the choice yesterday of Winchester or Magtech primers. I have noticed the Winchesters seem to be shorter in height than CCI primers and they seat lower in the primer pocket. So I grabbed a box of the Magtechs to give them a try.

Anyone have any experience with these primers, good or bad? Says made in Brazil.
__________________
5.56mm, reach out and touch something. .458 SOCOM,reach out and knock something down.


M70 Web Page
Stargazer is offline  
Old April 29, 2007, 11:07 AM   #2
DeltaWhiskey
Senior Member
 
Join Date: April 13, 2005
Posts: 226
I'm working my way through a case of them right now. They seem to be perfectly adequate, although I have had a few hard ones now and again. You should do just fine with them.
__________________
"I'm DeltaWhiskey on the other forums, too."
DeltaWhiskey is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:58 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05715 seconds with 9 queries