The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 25, 2007, 05:52 AM   #26
ShootingNut
Senior Member
 
Join Date: December 27, 2006
Location: Wisconsin
Posts: 1,470
Level teaspoon

of powder seems to work great for just about any load!
ShootingNut is offline  
Old April 25, 2007, 09:39 AM   #27
dgc940
Senior Member
 
Join Date: September 15, 2005
Location: Graham Texas
Posts: 258
Like brickeyee said!
My rcbs does the very same thing yours is! when dusty/dirty i take a qtip diped in acohol clean the knife and knife edges then blow clean then it works great till dirty again! They say keep covered till needed but I dont so I blow it clean before use. But like said when it gets dirty mine is very inconsistant it will vary as much as .1 -.2 grain. try it its free?
__________________
Some people say what they think!
Some say what they know!
Then there's those that think they know what they are saying!
dgc940 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:48 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06457 seconds with 9 queries