The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 24, 2007, 12:39 AM   #1
H&R12
Junior Member
 
Join Date: December 9, 2006
Location: SE Michigan. Hunt in the North Woods
Posts: 13
44 mag loads - advice

Just getting into loading with cast bullets. Using 255 gr. WFN BP Cast Perf. Wondering about a few loads I'm working up. 11 gr. of Unique, 11 gr. of Herco, and 10 gr. with Herco. Also trying 300 gr. WFN GC with 11 gr. Longshot and/or 11 gr Unique. Anybody have any experience with any of these loads. I shoot a 44 mag SRH with 7.5 in. bbl. I'm trying to find a 1200-1250 fps load. I have loaded XTP's alot, but want to try shooting cast. I'll be hunting mostly whitetail in Michigan. I haven't shot ant of these loads, but from the data I seem to favor Unique. Thanks.
H&R12 is offline  
Old January 24, 2007, 08:37 AM   #2
firechicken
Senior Member
 
Join Date: April 17, 2006
Location: Savannah, MO
Posts: 223
Your 11.0gr Unique load might be pushing it a little with a 255gr bullet. My plinking load for my 44 mag is 10.0 gr Unique under a 240gr SWC with CCI 350 primers. The primers are getting pretty flat with my 10.0gr load, actually flatter than with my 24.0 gr W296/240gr XTP load. The Unique load clocks right at 1200fps from my 7 1/2" Redhawk.
firechicken is offline  
Old January 24, 2007, 12:09 PM   #3
Steve 48
Member
 
Join Date: April 27, 2006
Posts: 59
My plinking load for a 250 gr Keith style bullet is 7.5 grs of Unique. You may be pushing the limit on yours. Steve48
Steve 48 is offline  
Old January 24, 2007, 07:09 PM   #4
H&R12
Junior Member
 
Join Date: December 9, 2006
Location: SE Michigan. Hunt in the North Woods
Posts: 13
An article from Beartooth Bullets list them shooting a 250 gr. WFN GC with 12 gr. of Unique with a MV of 1261. With that info, I thought I would drop a full grain with the Unique and go from there.
H&R12 is offline  
Old January 24, 2007, 07:45 PM   #5
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
I loaded up to 11.0 gr Unique with the 245 gr Keith boolit and it was decidedly too hot, even in my Redhawk.

Try some 2400 if you you want them more than medium warm.
Edward429451 is offline  
Old January 25, 2007, 06:26 PM   #6
txpete
Member
 
Join Date: June 18, 2006
Location: texas
Posts: 42
with my cast 245 swc's and 8.2 gr's unique will clover leaf out of my T/C 44 mag .my hunting load I use AA#9.
pete
txpete is offline  
Old January 28, 2007, 03:44 PM   #7
44 AMP
Staff
 
Join Date: March 11, 2006
Location: Upper US
Posts: 11,364
Unique

Is a medium rate pistol powder. It reaches max pressure before you get the max velocity obtainable with slower powders. Unique is best for medium to medium heavy loads. For heaviest loads, use a different powder, one with a slower buring rate, for best results.

I use 10.0gr Unique (240gr cast) as a general purpose load in .44 Mag, but I can't give you a vel figure, as I haven't clocked it.

I also use 10.0gr Unique (250gr cast) for a heavy end load for my .45 Colt Ruger Blackhawk. This load has been clocked @ 1070 avg fps from my 7.5in barrel. Heavy and accurate in my gun. I can (and have) gone heavier, but I have no real need to, and the load is not uncomfortable to shoot.

The same load in the .44Mag seems hotter (of course), but not at the painful level, unlike some other loads I have used. Next time I load a batch of plinkers for the .44, I will go a bit lighter.

One of my old Speer manuals (first book I found) lists a max of 8.0gr with the 240gr lead (swaged) for 898fps from a 7.5 in Ruger. It also lists a max of 11.0gr for jacketed 240gr bullets, with a vel of 1300+fps. 10.0gr gets you a bit over 1100fps. Just work up carefully, and be sure your cast bullets are cast hard, or you are going to have a lot of leading. Even hard cast bullets will start to lead the bore when you get close to 1200fps, generally. gas check designs let you go quite a bit faster. For the really fast stuff, shoot jacketed bullets for less trouble.
__________________
All else being equal (and it almost never is) bigger bullets tend to work better.
44 AMP is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:20 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07133 seconds with 9 queries