The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Gear and Accessories

Reply
 
Thread Tools
Old January 11, 2007, 07:06 PM   #1
Remmy
Senior Member
 
Join Date: June 22, 2001
Location: SC
Posts: 188
Adjusting the lever on leupold QRW rings

Ive got a couple of pairs of leupold qrw rings and wanted to know if anyone could tell me how to adjust the screw whether it be a combination of the torx drive tightening/loosening the screw while the lever is loosened or tightened...I just want them to line up in the same spot on the scope...now they are all pointing in different directions. This is really getting to me...
Remmy is offline  
Old January 14, 2007, 12:48 PM   #2
Remmy
Senior Member
 
Join Date: June 22, 2001
Location: SC
Posts: 188
Anybody have a comment on this?
Remmy is offline  
Old January 14, 2007, 04:01 PM   #3
Dave Haven
Senior Member
 
Join Date: February 1, 2000
Location: near Flagstaff, AZ
Posts: 790
1. Grasp the hub of the lever and pull straight away from the ring bottom.
2. Holding the lever away from the ring bottom, rotate the lever to the desired position.
3. Release the lever.
Dave Haven is offline  
Old January 15, 2007, 06:59 PM   #4
Remmy
Senior Member
 
Join Date: June 22, 2001
Location: SC
Posts: 188
Wow, so simple...

Thanks!!
Remmy is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:19 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06739 seconds with 9 queries