The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old October 27, 2006, 09:40 PM   #1
Ammo Junky
Senior Member
 
Join Date: March 11, 2006
Location: IL
Posts: 537
die polishing

I have an 30-06 die that is scratching brass. What is the easiest way to polish it? Mabey I could give it a long ride in the tumbler?

Thanks
AJ
__________________
Will work for brass.

I apologise in advance for spelling errors.
Ammo Junky is offline  
Old October 27, 2006, 10:17 PM   #2
TimRB
Senior Member
 
Join Date: May 18, 2004
Posts: 1,029
First check to see if bits of brass are stuck to the die and causing the scratches. If so, possibly you can clean it out with a bore solvent that you would use to remove copper fouling.

Tim
TimRB is offline  
Old October 27, 2006, 10:18 PM   #3
Ausserordeutlich
Junior member
 
Join Date: May 27, 2006
Posts: 996
I use a Dremel and Simichrome polish.
Ausserordeutlich is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:42 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06087 seconds with 9 queries