The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old October 14, 2006, 01:44 AM   #26
44 AMP
Join Date: March 11, 2006
Location: Upper US
Posts: 13,878
All of my medium seems rather small!

Personal problem, I guess!
All else being equal (and it almost never is) bigger bullets tend to work better.
44 AMP is offline  
Old October 14, 2006, 06:53 AM   #27
sleeping dog
Senior Member
Join Date: March 2, 2000
Location: MI
Posts: 536
A few years ago I ran a little experiment. I deprimed, cleaned, sized, then resized a bunch of .223 brass. Then sorted it into 2 piles, one with clean flash holes, one with walnut bits stuck in there.

I primed and loaded the brass, then went shooting. As far as I could tell, there was no difference in accuracy or POI with walnut or without. The primer flash apparently blows through walnut like it isn't there.

Now I don't bother checking or clearing the mediums.
sleeping dog is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:36 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.07149 seconds with 9 queries