The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 2, 2006, 11:14 PM   #1
tique
Junior Member
 
Join Date: December 8, 2002
Location: al
Posts: 6
WASR-10 scope mount rail removal?

I recently picked up a WASR-10, and it has what I assume to be the rail used to side mount a scope attached to the side of the reciever. I was wondering how hard this is to remove? Do I simply need to knock out the rivets holding it on, or will that mess up anything on the inside. I want to take it off due to the fact that it's keeping my mags with the mag-cinch from working... the spare one bumps up against the rail and make it impossible to insert the other in the gun. I tried mounting the mags in the mag-cinch side by side instead of offset, but it then bumps into the safety on the other side....
tique is offline  
Old March 3, 2006, 08:42 PM   #2
SpookBoy
Senior Member
 
Join Date: January 29, 2006
Location: mid tennessee
Posts: 414
Use a mag cinch of a different brand, or turn one mag upside down and space them verticly. that might help.
SpookBoy is offline  
Old March 4, 2006, 01:33 AM   #3
Ilovemyak47
Junior member
 
Join Date: February 24, 2006
Posts: 90
i had the same problem (if you can call it that), just move the other mag to the other side...or lower it a little, you don't need it so high it's hitting the scope rail...my $.02...
Ilovemyak47 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:58 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06123 seconds with 9 queries