The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 3, 2006, 01:16 PM   #1
FirstFreedom
Junior member
 
Join Date: May 31, 2004
Location: The Toll Road State, U.S.A.
Posts: 12,451
What diameter countersink bit for standard sling swivel studs?

?? Thanks.
FirstFreedom is offline  
Old March 4, 2006, 12:19 AM   #2
Rimrock
Junior member
 
Join Date: February 19, 2006
Location: CA
Posts: 273
"Drill a countersink hole with a 7/32 bit to a depth of 1/8. Then drill in the same hole to a depth of 1/2 with a 5/32" This according to the instructions on the Uncle Mike's label.
[IMG][/IMG]
Sorry about the huge pic.
Hope it helps!

Rimrock
Rimrock is offline  
Old March 4, 2006, 01:29 AM   #3
FirstFreedom
Junior member
 
Join Date: May 31, 2004
Location: The Toll Road State, U.S.A.
Posts: 12,451
Thanks, bud. Yeah, that helps alot.
FirstFreedom is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:57 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06691 seconds with 9 queries