The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 6, 2000, 07:58 PM   #1
acp Mikey
Member
 
Join Date: February 5, 2000
Posts: 71
As I was loading some 44 spl cases on my Dillon 550 the other day, I began to get some primers sideways in the pocket. I watched very closely and they seemed to be sitting in the seating part fine. My questions - What might cause this (primer pocket too tight, etc)? and What can I use to kill the primers so I can use the cases again. I might add these cases were once used and when I loaded them new, no such problems. Thanks for the help.
acp Mikey is offline  
Old September 7, 2000, 07:56 PM   #2
JoeHatley
Senior Member
 
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
I'll take a stab at helping ya...

The same thing happends to me from time to time. I've found that for me it's usually because the inside case mouth needs chamfering, or I'm belling the mouth too much.

Either of these things will cause the case to stick or grab a bit as it is lowered off the belling portion of the die. This causes a jerk in the operation of the press handle. When the jerk happens, the primer about to be seated gets jolted and it can turn sideways.

Hope that helps...

Joe


------------------
Go NRA
JoeHatley is offline  
Old September 7, 2000, 09:45 PM   #3
Joe Portale
Senior Member
 
Join Date: June 8, 1999
Location: Tucson, Arizona Territory
Posts: 715
Seen this before in my buddies 550. The folks at Dillon pretty clearly stated that it is vibration or jerking of the handle that causes the primers to flip.

------------------
Joe Portale
Tucson, Arizona Territory

"Those who turn their swords into plow shears,
end up plowing the fields of those who didn't"
Thomas Jefferson
Joe Portale is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05496 seconds with 9 queries