The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools
Old January 1, 2006, 11:28 AM   #1
Senior Member
Join Date: December 23, 2005
Location: Minnesota
Posts: 2,547
Sorting Brass by Weight??

I know this has been covered before and I don't want to debate "sorting" brass. I have decided that sorting my brass by weight is something I can do to keep me locked up in my loading room this winter. What I would like to know is "how do I group by weight"? I have a bunch of New 300WSM Winchester Brass that has been sized, trimmed and flash-hole deburred. It ranges from 215gr to 231gr. What percent, or how many grains, should I group from high to low within a batch?
steve4102 is offline  
Old January 1, 2006, 01:10 PM   #2
Senior Member
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,270
bye weight

Good idea for extreme accuracy, so write directly on each case as they get weighed, then test.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Old January 1, 2006, 08:12 PM   #3
Bob - S.C.
Join Date: March 13, 2005
Location: South Carolina
Posts: 19
I too, sort brass by weight. I have several small clear plastic tubs with lids and I mark the various weights on each tub using a blank address label. As I weigh the brass I just segregate, by weight, into each tub. It works pretty good and because they are clear, I can tell what is left in each one when loading. Granted, doing all that (yes, I sort bullets the same way, is very time consuming, but I think it definately improves accuracy. Good Luck!
Bob - S.C. is offline  
Old January 2, 2006, 07:33 PM   #4
Senior Member
Join Date: December 3, 2002
Posts: 1,154
Some people will use an arbitrary number like +/- 1.0grs. Personally, I'd find the two most extreme cases, shoot them along with some nominal cases and come up with a criteria that is actually meaningful.
30Cal is offline  
Old January 2, 2006, 07:44 PM   #5
Senior Member
Join Date: June 11, 2005
Location: eastern Kansas
Posts: 601

Some reloaders, when looking for extreme consistency, will determine the median, or mid point, weight of a particular lot of brass. Then they will sort out brass that doesn't come within one percent of the median weight. Some people do the same with bullets.
somerled is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:08 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05532 seconds with 9 queries