The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 10, 2000, 10:21 PM   #1
Don Parsley
Member
 
Join Date: January 27, 2000
Posts: 17
Question #1 - Is Federal, Remington, and the other top brands better than starline brass?

Question #2 - If you get once fired brass from reputable companies such as Dillon, etc.
Is this good brass?

Any commnents appreciated.

Don Parsley is offline  
Old March 11, 2000, 02:27 AM   #2
SVSUPER
Member
 
Join Date: February 3, 2000
Posts: 30
I shoot almost exclusively once fired brass. I have not bought any new brass for the past two years for my 40 s&w. As far as the quality of FED/ REM/ Win to starline it should all basically be equal. I cut a cross section of different manufacturers and found the case walls a little thicker on REM brass.
SVSUPER is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05705 seconds with 9 queries