The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old November 9, 1999, 07:18 PM   #1
orsogato
Senior Member
 
Join Date: July 20, 1999
Location: Steeler Country
Posts: 546
Hi,

I had this post in "The Art of the Rifle" and realized it should be here.

I recently read that if one tries to make a "Reduced" load for a 7mm Rem Mag that it creates dangerously high chamber pressures.


My Nosler reloading manual says that a good starting load for a 150 grain ballistic tip bullet is 48 grains of IMR 4895 this gives a mv of 2780 fps according to the book.

If I wanted to say only put 46 or 45 grains of 4895 probably dropping velocity 100 fps or so would this create a dangerous c.u.p. pressure situation.
orsogato is offline  
Old November 11, 1999, 07:41 PM   #2
Art Eatman
Staff Lead
 
Join Date: November 13, 1998
Location: Terlingua, TX, USA
Posts: 22,540
Hmmm. Dunno about the 4895. What I do know is that some of the slow-burning pistol powders are quite usable in large rifle cartridges for reduced loads.

As a for instance, around 20 grains of 2400 in an '06 will push a 169-grain lead gas check at around 1,900 ft/sec, +/-. Per the book I used, a gas-check bullet can be pushed to around 2,400.

So, going by guesswork and extrapolation, you could probably use, say, 25 grains of 2400 behind that 150-grain bullet and get maybe 2,300-2,400; maybe more. I'd gues that the use of oatmeal or some such filler would give more uniform ignition.

It's one of those deals where you're just gonna have to start somewhere and tinker. Then you can write a book, "Reduced Loads for the 7mm Maggie" and get rich.

, Art
Art Eatman is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:56 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05719 seconds with 9 queries