The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 10, 1999, 08:53 PM   #1
Oatka
Senior Member
 
Join Date: February 28, 1999
Location: Nevada
Posts: 3,076
Anyone know where I can get one of these? I CAN use a 1/4" wrench, but if possible I'd like the original. The old ones were made by Chapman of Durham, Conn., but I can't find any info on them.

I don't know if Lyman's new 450 sizer uses the same thing or a cheaper equivalent.
Oatka is offline  
Old September 10, 1999, 08:54 PM   #2
Oatka
Senior Member
 
Join Date: February 28, 1999
Location: Nevada
Posts: 3,076
Mr. Fastfingers -- that should be a #45 Lubricator/Sizer from the 1960s.
Oatka is offline  
Old September 10, 1999, 09:05 PM   #3
TEXAS LAWMAN
Senior Member
 
Join Date: August 27, 1999
Posts: 304
Chapman Mfg. Co.
471 New Haven Rd
POB 250
Durham, CT 06422
860/349-9228 FAX 860/349-0084
TEXAS LAWMAN is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05387 seconds with 9 queries