The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old May 13, 1999, 10:01 PM   #1
Michael Carlin
Senior Member
Join Date: October 13, 1998
Location: Fredericksburg, VA USA
Posts: 193
I need a .224 collet bullet puller to correct a mistake. The old CH I have (circa 1984-5) is a fine tool, but I only have a .308 collet.

Suggestions as to where I might purchase a .224 collet or a reasonably priced entire collet puller would be appreciated.

yours in marksmanship


[This message has been edited by Michael Carlin (edited May 13, 1999).]
Michael Carlin is offline  
Old May 14, 1999, 08:07 AM   #2
Staff Alumnus
Join Date: October 12, 1998
Location: Missouri
Posts: 1,986
You might try Midway. They have collets.
fal308 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:58 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08655 seconds with 9 queries