The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 22, 1999, 08:53 PM   #1
ChrisLe
Junior Member
 
Join Date: March 22, 1999
Location: Valley Stream, NY
Posts: 2
Hello All,
I've been using the BR3 measure successfully mounted on my bench. I've since begun using a turret press (Lyman TMagII) and would like to mount the BR3 on the turret. I'd like to mount the BR3 on lymans powder-through expanding/belling die. My question is as follows, the BR3 has a see through drop tube that is not removable thereby making it impossible to mount on any powder through die. Anybody successfully mount a BR3 on a turret press in a way that works successfully? Someone suggested I cut the drop tube but I would pefer to avoid it if possible.

Any and all suggestions would be appreciated.
ChrisLe is offline  
Old March 23, 1999, 12:53 AM   #2
swifter...
Senior Member
 
Join Date: March 16, 1999
Location: So. CA Mountains
Posts: 540
You might see if a Lee "Perfect" powder measure can be mounted. It looks like a tinker toy, but is very consistent. I think it can be mounted on the Lee turret and progressive... That would be better than modifying your Redding, and around $25, not too expensive.

------------------
Shoot carefully, swifter...
swifter... is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05529 seconds with 9 queries