The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old March 21, 2000, 12:14 PM   #1
Copythat
Member
 
Join Date: March 21, 2000
Posts: 26
What affects reliability in a 1911. Tight bushing to slide fit or tight bushing to barrel fit? Any help would be appreciated. Thanks guys.
Copythat is offline  
Old March 21, 2000, 11:22 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Copythat, actually neither will effect reliability. If the bushing is tight against the slide it's just going to ride the barrel. It doesn't move within the slide. If the bushing to barrel fit was tight enough to affect function you wouldn't be able to put it on the barrel to begin with. One area where a bushing might affect function is if it isn't relieved properly in the front and rear for the barrel to tip up as it unlocks. When I fit a bushing to a pistol, the bushing is reamed .001" larger than the barrel diameter and fit tightly enought into the slide to require a wrench to remove it. George
George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:40 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05193 seconds with 9 queries