The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old February 6, 2000, 10:35 AM   #1
Matt
Member
 
Join Date: September 14, 1999
Posts: 39
I have an old Harrington&Richardson 32 cal. revoler.This piece was a mass of rust when i got it,I've cleaned it all up and had her reblued.now i need to replace all the flat springs.I've ordered spring stock from Browells,and the basics of making springs seems easy enough,but I'd like to learn as much as possible before i start this stage.Does it matter what weight oil you use to quench?time in oil?is there any books covering this subject in detail?
Thanks,
Matt
Matt is offline  
Old February 6, 2000, 03:47 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Matt, you have your work "cut out" for you. The Brownells flat spring stock is pretty thick when you compare 1/16" to .010". That will be the hardest part of it. Getting the metal thinned. Making flat springs is relativly easy. Most small ones you can make on top of the kitchen stove. The method that works well for me it so lay the spring onto a burner and heat on high until cherry red. Then quench in 30wt motor oil. I have used 10wt so I really don't think that matters. After the spring has cooled in the oil suspend it in molten lead for 4 to 8 minutes. I use my Lee lead pot for this. It maintains the proper temperature. After that, either you have a spring or you don't. It isn't what you'd call an exact science. In Brownells Gunsmith Kinks series there are several different methods outlined. It's a pretty good source for tips on gun work. George
George Stringer is offline  
Old February 6, 2000, 09:45 PM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,951
Most of the springs you will need for that H&R can be bought from Wolfe or Brownells. They may need some fitting, but that would be easier than making them.

Jim
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06379 seconds with 9 queries