The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 31, 2000, 04:56 PM   #1
Erik
Senior Member
 
Join Date: December 24, 1999
Location: America
Posts: 3,479
How easy is it to dehorn your own pistol? What is required?

Also, assuming the pistol is stainless steele, what needs to be done to "restore" the finish afterwards?

Thanks,
Erik
Erik is offline  
Old January 31, 2000, 06:25 PM   #2
Rosco Benson
Senior Member
 
Join Date: October 20, 1998
Posts: 374
I've done several by just breaking the sharp edges with a fine file and then rounding these edges a bit with a "rust eraser" (a block of rubber with abrasive grit embedded in it.

To really "refinish" most stainless pistols, you would need to mask off the flats and bead blast the "edges". As a practical matter, one can normally get the pistol looking okay with just a bit of scotchbrite...as long as you don't get too carried away on the bead blasted portions.

Rosco

Rosco Benson is offline  
Old January 31, 2000, 11:36 PM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,847
"Dehorning" usually refers to removing or cutting down the hammer spur of a revolver. It can be done with a grinding wheel. If you are referring to simply removing sharp edges, Rosco's advice is good. A full "melt down" is more extreme, but basically the same thing. (FWIW, I think a "melt down" looks like %^&*. And you can quote me.)

Jim
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:05 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06516 seconds with 9 queries