The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 20, 1999, 07:41 PM   #1
Matt
Member
 
Join Date: September 14, 1999
Posts: 39
Cleaning my colt 70 series last night i discovered a very small crack on the frame right at the slide stop.Can any thing be done or should i start shoping for a frame?This gun was bought from a pin shooter,and is almost all aftermarket,if nothing can be done to save this frame,who's would you recommend?
thanks
Matt
Matt is offline  
Old December 20, 1999, 09:33 PM   #2
Mikey
Senior Member
 
Join Date: November 14, 1998
Location: Tennessee
Posts: 885
If the crack is at the part of the frame rail just above the squarish hole in the frame that the slide stop engagement surface protrudes through, you are probably OK. Most aftermarket frames don't even have that part of the rail at all. They just cut a gap for the slide stop. STI frames have a whole center section missing from both rails!

You may want to have a smith look at it and even machine that piece away to relieve any stress that might be there. It may help prevent more cracking.

Mikey
Mikey is offline  
Old December 20, 1999, 11:18 PM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 18,670
Hi, Matt,

It is a little late for you on this but perhaps someone else might benefit.

I recommend agaist buying a gun from a pin shooter. They tend to load hot and the guns suffer accordingly.

Jim
James K is offline  
Old December 21, 1999, 12:25 PM   #4
JoeHatley
Senior Member
 
Join Date: July 1, 1999
Location: Iowa
Posts: 2,135
Matt, your frame can possibly be heli-arch welded, but unless it gets worse, I would just leave it alone. I've seen cracked frames last many years before they get bad enough to effect functioning.

If the crack starts at the slide stop hole, putting a slight radius on the area may slow it down. For a while...

Probably time to start watching for a replacement at your local gun shows, or have a dealer order you and Essex Arms frame.

Good Luck...

Joe


------------------
Go NRA
JoeHatley is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06160 seconds with 9 queries