The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 19, 1999, 10:38 PM   #1
blooch
Senior Member
 
Join Date: December 5, 1999
Location: texas
Posts: 152
i have an old para ordnance frame kit that with the exception of this one problem is totally reliabe. it seems after 6-8 rounds fired the slide stop lever will catch the slide even though the gun is not empty. it does not matter which magazine is used ( i have several). the para frame has a wilson slide and brown barrel if that helps. help
blooch is offline  
Old December 19, 1999, 11:58 PM   #2
Bryan Whited
Member
 
Join Date: December 1, 1998
Location: Chino Hills, Ca, USA
Posts: 63
This is called false slide lock.
It can be caused by many different things. The two most common are:
1. Lever is being knocked up by a loose thumb or finger. Have someone watch you shoot to check on grip and if any fingers and/or thumbs are moving more then they should.
2. Slide lock lever has a 90 degree edge where it catches the slide. The angle should be 90 degress but it needs to be rounded some to ensure that the slide can knock it back down if it just makes contact. To see if this is the problem shoot the firearm until it goes into false slide lock and see how much the slide lock lever engauges into the slide. If it only is up enough the minimum it takes to lock the slide then this may be the cause. It also could be a loose finger and/or thumb. Either case by rounding the corner off the slide release would be forced back down to where it should be.
Bryan Whited is offline  
Old December 20, 1999, 06:20 AM   #3
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Blooch, not to argue with Bryan but check the inside of the release where it contacts the magazine follower. More than likely you will find brass marks on it. Just relieve this area with a file, a little at a time, until the bullet noses no longer contact it. This can also be caused by inertia. It's more common with extended releases. That can be remedied by cutting/drilling a small detent notch in the end of the release to give the plunger something to hold on to. George
George Stringer is offline  
Old December 20, 1999, 11:52 AM   #4
Bryan Whited
Member
 
Join Date: December 1, 1998
Location: Chino Hills, Ca, USA
Posts: 63
George is correct that is another very common problem. I have heard of it a lot but can not remember the last time I ran into it.
Thanks George, didn't think of that one.
Bryan Whited is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06043 seconds with 9 queries