The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 16, 1999, 06:43 PM   #1
Sport
Senior Member
 
Join Date: October 4, 1999
Posts: 317


I'd like to try my hand at removing
the trigger creep on my Colt series
70 government model.
Your advice is appreciated.
Sport is offline  
Old December 16, 1999, 09:59 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Sport, you're probably going to think I'm not a very good one. I don't give advise on trigger work. This is an area that I believe is best left to a gunsmith. George
George Stringer is offline  
Old December 16, 1999, 11:38 PM   #3
WalterGAII
Junior member
 
Join Date: November 7, 1999
Posts: 1,516
Fortunately, my 70 Series G.C. has no creep. Has a great trigger. I've adjusted all the overtravel out, as well. Wish I could help with the Government model, but George is right about the creep on the 1911. Go to a competent 1911 gunsmith.

[This message has been edited by WalterGAII (edited December 17, 1999).]
WalterGAII is offline  
Old December 17, 1999, 05:45 AM   #4
Sport
Senior Member
 
Join Date: October 4, 1999
Posts: 317


To a gunsmith it shall go.
Sport is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:14 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05800 seconds with 9 queries