The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 22, 1999, 04:14 AM   #1
jbyrd
Junior Member
 
Join Date: July 14, 1999
Posts: 9
This is a silly question but one I have to ask as I am an ignorant person. I see 1911 parts everywhere. How many of these 1911 parts would fit into my M1991A1? I have never compared a 1911 to a 1991 side by side.
jbyrd is offline  
Old July 22, 1999, 05:59 AM   #2
Jim V
Senior Member
 
Join Date: January 31, 1999
Location: SE Michigan - USA
Posts: 4,038
Just about all the 1911 parts will fit the 1991 except the firing pin, the hammer and sear and they would work if the pistol did nnot have the firing pin safety installed.

------------------
Ne Conjuge Nobiscum
"If there be treachery, let there be jehad!"

Jim V is offline  
Old July 22, 1999, 08:02 AM   #3
Rosco Benson
Senior Member
 
Join Date: October 20, 1998
Posts: 374
Actually, the sear is no different in pre or post-series 80 guns. The hammers ARE different, in that the pre-series 80 hammers have a captive half-cock notch and the newer ones just have a non-captive "shelf"...but they will interchange with no problems.

Rosco
Rosco Benson is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06222 seconds with 9 queries